Plate Bearing Test Apparatus


Plate Bearing Test Apparatus

Specifications

Type Lump Test Apparatus
Material Metal
Application Lump Testing
Color Natural
Voltage 110V
Dimension 300mmx320mmx425mm
Power 1KV
Driven Type Electric
Phase Double Phase
Warranty 1 Year
Temperature 0-50°C
Vacuum range 150-300mm


The company introduces itself as one of the major Manufacturers and Suppliers based in India. We offer Plate Bearing Test Apparatus, which is available in various specifications. These Plate Bearing Test Apparatuses are extensively used for soil testing. This is for estimating the bearing capacity of shallow foundations in situ and for the design of flexible pavement. In the test procedure a steel plate is subjected to gradually increasing load and settlements of the plates recorded. Maximum bearing capacity is noted as that load at which the plate starts sinking rapidly.

Standard :

  • IS: 1888-1962


Specifications :
The basic outfit consists of :

  • 50 Tone Hydraulic jack with separate pumping unit fixed to it a 0 -500 KN. x 0.5 KN
  • Pressure gauge and flexible metal pipe 5 meter long- 1 No.
  • Special ball and socket arrangement between the jack and the bearing plate -1 No
  • Extension rod 12mm. diameter x 25cm. long for taking dial gauge readings -16 Nos
  • Magnetic base with female thread on top for holding extension rod 4 Nos
  • Top end plate, 50mm, diameter with male thread for fitting onto the extension rods and
  • Positioning the dial gauge plunger - 4 Nos
  • Column 15cm. diax25cm long with flanges complete with four bolts and nuts -2 Nos
  • Column 15cm. diax50cm long with flanges com plete with four bolts and nuts -1 Nos
  • Bridge support of welded steel angle construction, 5 meter span and stands approximately
  • 30cm, high. Fitted with two quick release clamps for positioning and holding the dial bracket-2 Nos
  • Plane MS Plate 60cms x 60cms. square x 25mm thick
  • Plane MS Plate 45cms x 45cms. square x 25mm thick
  • Plane MS Plate 30cms x 30cms. square x 25mm thick
  • Dial Gauge 0.01mm x 25mm.- 4 Nos


Accessories :

  • Plane M.S. Plate 75cm x 25mm thick
  • Plane MS Plate 50cm x 25mm thick
  • Grooved MS Plate 60cms x 60cms x 25mm. thick
  • Grooved MS Plate 45cms x 45cms x 25mm. thick
  • Grooved MS Plate 30cms x 30cms x 25mm. thick
  • Grooved MS Plate 75cms x 75cms x 25mm. thick


Note :

  • When plates of size more than 30 cm sq. are used, in order to prevent deflections of the edge, a series of smaller plates are advised to be placed concentrically on the bottom plate
  • Flexible rubber pipe 1 meter length can be supplied for the hydraulic jack in place of metal pipe at extra cost

Yes! I am interested



  • Explore More Products




Looking for "Plate Bearing Test Apparatus" ?